PATC Course: Programming ARM based prototypes
Date: 16/May/2014
The course will take place in
Barcelona Supercomputing Centre,
within the UPC Campus Nord premises.
Room VS219, Vertex Building (green on the map)
S indicates that the room is 2 floors below the entrance level.
Target group: Standard HPC users, some knowledge of multicore and GPU-accelerated systems is desirable, but not required. Level: ITERMEDIATE: for participants with some theoretical and practical knowledge (All courses are designed for specialists with at least 1st cycle degree)
Cost: There is no registration fee. The attendees would need to cover the expenses for travel, accommodation and meals.
Primary tabs
Session 1 9:00 am (2h):
1. The Montblanc Project
2. ARM based machines: Architecture Overview
3. Discussion
Session 2 (1h + 1h hands-on):
Using ARM based machines (How to get access, Job Execution, Support) ( 1:30h )
Lunch Break (13:00 to 14:00)
Session 3 (1h + 1h hands-on ):
Developing application on ARM based machines(GNU tool chain, examples, etc…)
END of COURSE