LSF_DEBUG_LIM=log_class
Sets the log class for debugging LIM.
Specifies the log class filtering to be applied to LIM. Only messages belonging to the specified log class are recorded.
The LSF_DEBUG_LIM sets the log class and is used in combination with EGO_LOG_MASK in ego,conf, which sets the log level.
EGO_LOG_MASK=LOG_DEBUGLSF_DEBUG_LIM=LC_TRACE If EGO is enabled, LSF_LOG_MASK no longer specifies LIM logging level. Use EGO_LOG_MASK in ego.conf to control message logging for LIM. The default value for EGO_LOG_MASK is LOG_WARNING.
You need to restart the daemons after setting LSF_DEBUG_LIM for your changes to take effect.
If you use the command lsadmin limdebug to temporarily change this parameter without changing lsf.conf, you do not need to restart the daemons.
LSF_DEBUG_LIM="LC_TRACE LC_EXEC"This parameter can also be defined from the command line.
LC_AFS and LC2_AFS: Log AFS messages
LC_AUTH and LC2_AUTH: Log authentication messages
LC_CHKPNT - log checkpointing messages
LC_COMM and LC2_COMM: Log communication messages
LC_DCE and LC2_DCE: Log messages pertaining to DCE support
LC_EXEC and LC2_EXEC: Log significant steps for job execution
LC_FILE and LC2_FILE: Log file transfer messages
LC_HANG and LC2_HANG: Mark where a program might hang
LC_JGRP - Log job group messages
LC_LICENSE and LC2_LICENSE : Log license management messages (LC_LICENCE is also supported for backward compatibility)
LC_LICSCHED - Log License Scheduler messages
LC_MEMORY - Log memory limit messages
LC_MULTI and LC2_MULTI: Log messages pertaining to MultiCluster
LC_PIM and LC2_PIM: Log PIM messages
LC_RESOURCE - Log resource broker messages
LC_SIGNAL and LC2_SIGNAL: Log messages pertaining to signals
LC_TRACE and LC2_TRACE: Log significant program walk steps
LC_XDR and LC2_XDR: Log everything transferred by XDR
LC2_TOPOLOGY: Debug the hardware topology detection during runtime
EGO_DEBUG_LIM
Not defined
LSF_DEBUG_RES, LSF_CMD_LOGDIR, LSF_CMD_LOG_MASK, LSF_LOG_MASK, LSF_LOGDIR